NEW! CamMotion Micro Color CMOS Board Cams - ONLY $119.95 and $149.95
- General Information:
- Single-chip 1/3" format video camera on a tiny 30mm x 30mm board
- Latest hi-tech super low power CMOS ultra-miniature design, with audio
- NTSC Composite video *and* AUDIO (tiny 6mm condenser microphone)
- Power supply: 12V DC 20mA, or 5V DC 40mA (low power: 200-240mw)
- Operating temperature: 14F to 122F (-10C to +50C)
- Wired connector: +12V/20mA, ground, video out, audio out
- Video Specs and Lens Information:
- Sensitivity boost (+18dB)/AGC on-off - automatic
- Auto exposure/gain/white balance
- Aperture correction
- Image device: 1/3" CMOS, 510H x 492V (250,920 pixels)
- Internal sync
- Horizontal resolution: 330 TV lines
- Minimum illumination: 5 lux@f1.4
- Electronic iris: 1/60 to 1/2,000sce
- Backlight compensation: factory setting (center zone detection)
- Video output: 1.0Vp-p, 75ohm
- Fixed lens: Focal Length 3.6mm (60 deg fov) or 25mm (9 deg fov - about 7X magnification)
- Lens is screw-adjustable focus with locking set-screw
- Dimensional Information:
- Board size: 30 x 30 mm (about 1.2 x 1.2 inch - square)
- 2 mounting holes for 2/56 size metric screws located on 27mm centers at opposite corners of board
- 3.6mm lens extends about 25mm from front side of the camera board, 16mm diameter
- 25mm lens extends about 35mm from front side of the camera board, 28mm diameter
- 4-lead wiring connector extends about 1/3" from rear of the camera board
- microphone diameter - 6mm
- Includes:
- board 'chip' camera with specs as above
- hookup/wiring information sheet
- power, ground, audio, and video leads (about 100mm long, solderable) all on one 4-lead removable connector on rear of cam board
- micro condenser microphone attached (on 50mm leads) to two-lead removable connector on front of cam board
- screw-adjustable-focus lens with focus-locking set-screw (3.6mm or 25mm focal length)
- lens cover cap
- Price:
- Price: 3.6mm lens version - $119.95
- Price: 25mm lens version - $149.95 (about 7X magnification compared to 3.6mm)
Thank you for visiting the Videobotics Micro CMOS Board Cam Page.
- Single-chip 1/3" format video camera on a tiny 30mm x 30mm board
- Latest hi-tech super low power CMOS ultra-miniature design, with audio
- NTSC Composite video *and* AUDIO (tiny 6mm condenser microphone)
- Power supply: 12V DC 20mA, or 5V DC 40mA (low power: 200-240mw)
- Operating temperature: 14F to 122F (-10C to +50C)
- Wired connector: +12V/20mA, ground, video out, audio out
- Sensitivity boost (+18dB)/AGC on-off - automatic
- Auto exposure/gain/white balance
- Aperture correction
- Image device: 1/3" CMOS, 510H x 492V (250,920 pixels)
- Internal sync
- Horizontal resolution: 330 TV lines
- Minimum illumination: 5 lux@f1.4
- Electronic iris: 1/60 to 1/2,000sce
- Backlight compensation: factory setting (center zone detection)
- Video output: 1.0Vp-p, 75ohm
- Fixed lens: Focal Length 3.6mm (60 deg fov) or 25mm (9 deg fov - about 7X magnification)
- Lens is screw-adjustable focus with locking set-screw
- Board size: 30 x 30 mm (about 1.2 x 1.2 inch - square)
- 2 mounting holes for 2/56 size metric screws located on 27mm centers at opposite corners of board
- 3.6mm lens extends about 25mm from front side of the camera board, 16mm diameter
- 25mm lens extends about 35mm from front side of the camera board, 28mm diameter
- 4-lead wiring connector extends about 1/3" from rear of the camera board
- microphone diameter - 6mm
- board 'chip' camera with specs as above
- hookup/wiring information sheet
- power, ground, audio, and video leads (about 100mm long, solderable) all on one 4-lead removable connector on rear of cam board
- micro condenser microphone attached (on 50mm leads) to two-lead removable connector on front of cam board
- screw-adjustable-focus lens with focus-locking set-screw (3.6mm or 25mm focal length)
- lens cover cap
- Price: 3.6mm lens version - $119.95
- Price: 25mm lens version - $149.95 (about 7X magnification compared to 3.6mm)